Wherever you place the first orientation point on the left, that will be the home point from which the drawing is referenced in webcontrol or groundcontrol. Orientation points tell your maslow where to cut with respect to home. Set up origin points with the same layer selectedД®xtensions->gcodetools->orientation points Cutting successfully at 4 mm can be done and even 5 mm, but there is a proportional speed drop that must accompany it to generate fine dust and the bit cool so it doesnвЂ™t overheat.Д«. Depth step is the depth your tool will cut in 1 pass in mm. Penetration feed is 800 for the z insertion for a first gen z axis.

Penetration angle is always 90 for maslow because the router on the sled is flat on the work surface. This picture for this example was cut at 550 with a 1/4' bit. You can cut at 750, but it may not be good quality and your tool will dull faster if it gets hot. Set your feed rate based on your material in mm/min (between 300 and 800). change diameter to 6.35 if you are using a 1/4' bit or 3.175 if you are using a 1/8th inch bit.

or just click to select the text and then click on the text tool bar on the left or the right side of the page. If your attempts to edit add numbers over the top, then undo and retry. Do this by double clicking on them and then when you get the text cursor you can edit them. If you paste it in and it isnвЂ™t lined up, you can move it and it will snap to the other layer so it will be lined up perfectly.ДЄfter pasting, they may not line up, so move it if you need to. With both layers visible, you should not be able to tell them apart, but you can toggle which one you see hiding or viewing it in the layer viewer. CTRL+C will copy everything that is selected.Select all (CTRL+A) or draw a box around everything If you canвЂ™t select anything on the layer, you can right click on the layer and select unlock all and then unhide all to see everything. DonвЂ™t mess with the lock or you wonвЂ™t be able to edit or select anything in that layer.

If the eye is black with eyelashes this is viewable, if greyed and looks closed, then it is hidden. In the layer viewer on the right, you can select which layer is visible by clicking on the eye. Move the tab layer below the first layer as a matter of convention because it is intuitive that the top layer gets cut first, then the tabs at the bottom get cut last. rename it вЂњtabsвЂќ by using the right click menu.

Open source g code generator